Areca ARC-1213-4I Bedienungsanleitung PDF herunterladen (Seite 33)

HARDWARE INSTALLATION

Note:

A cable for the global indicator comes with your computer

system. Cables for the individual drive LEDs may come with a

drive cage, or you may need to purchase them.

LED Normal Status Problem Indication

Fault LED When the fault LED is solid

illuminated, there is no disk

present. When the fault LED

is off, then disk is present

and status is normal.

When the fault LED is slow blinking

(2 times/sec), that disk drive has

failed and should be hot-swapped

immediately. When the activity

LED is illuminated and fault LED is

fast blinking (10 times/sec) there

is rebuilding activity on that disk

drive.

A: Individual Activity/Fault LED and Global Indicator Con-

nector

Most of the backplane has supported the HDD activity from the

HDD. The 6Gb/s SAS RAID controller also provides the fault activity

for fault LED. Connect the cables for the drive fault LEDs between

the backplane of the cage and the respective connector on the

6Gb/s SAS RAID controller.

The following table is the fault LED signal behavior.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 197 198

Keine Kommentare

Areca ARC-1213-4I Bedienungsanleitung Seite 33