Areca ARC-1213-4I Bedienungsanleitung PDF herunterladen (Seite 22)

HARDWARE INSTALLATION

• Before opening the system cover, turn off power switches and

unplug the power cords. Do not reconnect the power cords until

you have replaced the covers.

Electrostatic Discharge

Static electricity can cause serious damage to the electronic com-

ponents on this 6Gb/s SAS RAID controller. To avoid damage

caused by electrostatic discharge, observe the following precau-

tions:

• Do not remove the 6Gb/s SAS RAID controller from its anti-stat-

ic packaging until you are ready to install it into a computer case.

• Handle the 6Gb/s SAS RAID controller by its edges or by the

metal mounting brackets at its each end.

• Before you handle the 6Gb/s SAS RAID controller in any way,

touch a grounded, anti-static surface, such as an unpainted por-

tion of the system chassis, for a few seconds to discharge any

built-up static electricity.

2.3 Installation

Use the following instructions below to install a PCIe 2.0 6Gb/s SAS

RAID controller.

Step 1. Unpack

Unpack and remove the PCIe 2.0 6Gb/s SAS RAID controller from

the package. Inspect it carefully, if anything is missing or damaged,

contact your local dealer.

Step 2. Power PC/Server Off

Turn off computer and remove the AC power cord. Remove the

system’s cover. For the instructions, please see the computer sys-

tem documentation.

Step 3. Check Memory Module

Be sure of the cache memory module is present and seated rmly

in the DIMM socket (DDR3-1333) for ARC1882ix-12/16/24 models.

The physical memory conguration for ARC-1882ix series is one

240-pin DDR3-1333 ECC single rank SDRAM DIMM module.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 197 198

Keine Kommentare

Areca ARC-1213-4I Bedienungsanleitung Seite 22